R&S FSV-K7 Operating Manual page 107

®
R&S FSV-K7/K7S
Manual operation:
CALCulate<n>:MARKer<m>:X:SLIMits[:STATe] <State>
This command turns marker search limits on and off.
If the power measurement in zero span is active, this command limits the evaluation
range on the trace.
Suffix:
<n>
<m>
Parameters:
<State>
Example:
CALCulate<n>:MARKer<m>:X:SSIZe <StepSize>
This command defines the step size of the rotary knob for marker or delta marker value
changes. It only takes effect in manual operation.
The marker step size is unavailable for statistical measurements.
Suffix:
<n>
<m>
Parameters:
<StepSize>
Example:
Manual operation:
CALCulate<n>:MARKer<m>:Y?
This command queries the measured value of a marker.
Operating Manual 1176.7561.02 ─ 06
Analog Demodulation Option R&S FSV–K7
Remote Commands of the Analog Demodulation (R&S FSV–K7)
See "Right Limit" on page 75
.
Selects the measurement window.
marker
ON | OFF
*RST: OFF
CALC:MARK:X:SLIM ON
Switches on search limitation.
.
irrelevant
irrelevant
STANdard
step size corresponds to space between two pixels
POINts
step size corresponds to space between two measured values
(number of measured values is defined via the
[SENSe<n>:]SWEep:POINts command, see
on page 157)
]SWEep:POINts
*RST: POINts
CALC:MARK:X:SSIZ STAN
Sets the measured value step size.
See "Stepsize Standard"
See "Stepsize Sweep Points"
[SENSe:
on page 70
on page 70
107