R&S FSV-K7 Operating Manual page 76

®
R&S FSV-K7/K7S
2.2.12 Softkeys of the Input/Output Menu
The following table shows all softkeys available in the "Input/Output" menu. It is possi-
ble that your instrument configuration does not provide all softkeys. If a softkey is only
available with a special option, model or (measurement) mode, this information is pro-
vided in the corresponding softkey description.
Input
Noise
Video
Tracking
Power
Trigger
External
Probe
Signal
EXIQ..............................................................................................................................78
Digital IQ
Input (AC/DC)
Toggles the RF input of the R&S FSVA/FSV between AC and DC coupling.
This function is not available for input from the R&S Digital I/Q Interface (option
R&S FSV-B17).
Remote command:
INPut:COUPling
Noise Source
Switches the supply voltage for an external noise source on or off.
Remote command:
DIAGnostic<n>:SERVice:NSOurce
Video Output
Sends a video output signal according to the measured level to the connector on the
rear panel of the R&S FSVA/FSV.
Note: Video output does not return valid values in IQ or FFT mode.
Remote command:
OUTP:IF VID , see
Operating Manual 1176.7561.02 ─ 06
(AC/DC)................................................................................................................76
Source.................................................................................................................76
Output................................................................................................................. 76
Generator....................................................................................................... 77
Sensor................................................................................................................77
Out.................................................................................................................... 77
Mixer............................................................................................................... 77
Config................................................................................................................. 77
Source................................................................................................................77
└ Input Path........................................................................................................77
└ Connected Device...........................................................................................78
└ Input Sample Rate.......................................................................................... 78
└ Full Scale Level...............................................................................................78
└ Level Unit........................................................................................................ 78
└ Adjust Reference Level to Full Scale
└ TX Settings..................................................................................................... 79
└ RX Settings..................................................................................................... 79
└ Send To...........................................................................................................79
└ Firmware Update............................................................................................ 79
└ R&S Support................................................................................................... 79
└ DigIConf.......................................................................................................... 79
Info................................................................................................................ 80
on page 178
OUTPut:IF[:SOURce]
Analog Demodulation Option R&S FSV–K7
Softkeys of the Analog Demodulation option
Level.................................................... 78
on page 185
on page 184
76