R&S FSV-K7 Operating Manual page 165

®
R&S FSV-K7/K7S
Example:
Mode:
TRIGger<n>[:SEQuence]:LEVel:BBPower <Level>
This command sets the level of the baseband power trigger source (for digital input via
the R&S Digital I/Q Interface, R&S FSV-B17).
Suffix:
<n>
Parameters:
<Level>
Example:
Mode:
Manual operation:
TRIGger<n>[:SEQuence]:LEVel:FM <Level>
The command sets the level when FM-modulated signals are used as trigger source.
For triggering with AF, AM, AMRelative, FM, and PM trigger sources to be successful,
the measurement time must cover at least 5 periods of the audio signal.
Suffix:
n
Parameters:
<Level>
Example:
Mode:
TRIGger<n>[:SEQuence]:LEVel:IFPower <TriggerLevel>
This command defines the power level at the third intermediate frequency that must be
exceeded to cause a trigger event. Note that any RF attenuation or preamplification is
considered when the trigger level is analyzed. If defined, a reference level offset is also
considered.
Suffix:
<n>
Parameters:
<TriggerLevel>
Operating Manual 1176.7561.02 ─ 06
Analog Demodulation Option R&S FSV–K7
Remote Commands of the Analog Demodulation (R&S FSV–K7)
TRIG:LEV:AM:REL -20 %
Sets the AM trigger threshold to -20 %
ADEMOD
.
irrelevant
Range: -50 dBm to +20 dBm
*RST: -20 DBM
TRIG:LEV:BB -30DBM
All
See "Trigger Level" on page 66
.
irrelevant
Range: -10 to +10
*RST: 0 Hz
Default unit: MHz
TRIG:LEV:FM 10 kHz
Sets the FM trigger threshold to 10 kHz
ADEMOD
.
irrelevant
*RST: -20 dBm
165