R&S FSV-K7 Operating Manual page 147

®
R&S FSV-K7/K7S
[SENSe:]ADJust:LEVel
This command automatically sets the optimal reference level for the current measure-
ment.
You can define a threshold that the signal must exceed before the reference level is
adjusted, see
[SENSe:]ADJust:CONFiguration:HYSTeresis:LOWer.
Example:
Manual operation:
[SENSe:]ADJust:SCALe:Y:AUTO[:CONTinuous] <state>
Activates automatic scaling of the y-axis. Currently auto-scaling is only available for AF
measurements. RF power and RF spectrum measurements are not affected by the
auto-scaling.
Parameters:
<state>
Example:
Mode:
Manual operation:
2.3.6.5 SENSe:BANDwidth Subsystem (Analog Demodulation, R&S FSV–K7)
This subsystem controls the setting of the instruments filter bandwidths. Both groups of
commands (BANDwidth and BWIDth) perform the same functions.
[SENSe:]BANDwidth|BWIDth:DEMod
[SENSe:]BANDwidth:DEMod:TYPE
[SENSe:]BANDwidth|BWIDth:DEMod <Bandwidth>
This command sets the bandwidth for analog demodulation. Depending on the
selected demodulation bandwidth, the instrument selects the required sampling rate.
The available values of the demodulation bandwidths are determined by the sampling
rates. For details on the correlation between demodulation bandwidth and sampling
rate refer to
on page 13.
Parameters:
<Bandwidth>
Example:
Mode:
Operating Manual 1176.7561.02 ─ 06
Remote Commands of the Analog Demodulation (R&S FSV–K7)
[SENSe:]ADJust:CONFiguration:HYSTeresis:UPPer
ADJ:LEV
See "Auto Level"
ON | OFF
*RST:
SENS1:ADJ:SCAL:Y:AUTO ON
ADEMOD, SFM
See "AF Auto Scale"
...............................................................................147
................................................................................. 148
Chapter 2.1.3, "Sample Rate, Measurement Time and Trigger
*RST:
BAND:DEM 1MHz
Sets test bandwidth to 1 MHz
A-F, ADEMOD
Analog Demodulation Option R&S FSV–K7
on page 50
OFF
on page 51
5 MHz
and
Offset",
147