R&S FSV-K7 Operating Manual page 128

®
R&S FSV-K7/K7S
[SENSe:]ADEMod:AM:RELative:AFSPectrum:RESult? <TraceMode>
This command reads out the AF spectrum result data of the AM-demodulated signal
for the specified result type. The data format of the output data is determined with the
FORMat command (see
and Binary
The output unit is dB (logarithmic display) or % (linear display).
Query parameters:
<TraceMode>
Example:
Usage:
Mode:
Operating Manual 1176.7561.02 ─ 06
Remote Commands of the Analog Demodulation (R&S FSV–K7)
Chapter 2.3.6.2, "Formats for Returned Values: ASCII Format
Format", on page 118).
WRITe | AVERage | MAXHold | MINHold | VIEW
The specified trace mode must be one of those configured by
[SENSe:]ADEMod:AM[:ABSolute][:TDOMain][:TYPE]
on page 125. Otherwise a query error is generated.
For details on trace modes see
Result Types",
ADEM:SET 8MHz,32000,EXT,POS,-500,30
Sets the demodulator
ADEM:FM AVER,MAXH,MINH
Selects the FM results to be measured
ADEM:AM:REL WRIT,OFF,OFF
Selects the AM results to be measured
ADEM:AM:REL:AFSP WRIT,OFF,OFF
Selects the AF spectrum results of the demodulated AM signal
to be measured
ADEM ON
Switches on the demodulator
INIT; WAI
Starts the measurement and waits for the termination
FORM ASC
Selects the output format
ADEM:FM:RES? AVER
Reads the FM average result data
ADEM:FM:RES? MAXH
Reads the FM Maxhold result data
ADEM:FM:RES? MINH
Reads the FM Minhold result data
ADEM:AM:REL:RES? WRIT
Reads the current AM result data
ADEM:AM:REL:AFSP:RES? WRIT
Reads the current AF spectrum result data of the demodulated
AM signal
Query only
ADEMOD
Analog Demodulation Option R&S FSV–K7
Chapter 2.3.6.1, "Trace Mode
on page 118.
128