R&S FSV-K7 Operating Manual page 137

®
R&S FSV-K7/K7S
Example:
Mode:
[SENSe:]ADEMod:PM:RPOint[:X] <Time>
This command determines the position where the phase of the PM-demodulated signal
is set to 0 rad. The maximum possible value depends on the measurement time
selected in the instrument; this value is output in response to the query
ADEM:PM:RPO:X? MAX.
Parameters:
<Time>
Example:
Operating Manual 1176.7561.02 ─ 06
Analog Demodulation Option R&S FSV–K7
Remote Commands of the Analog Demodulation (R&S FSV–K7)
ADEM:SET 8MHz,32000,EXT,POS,-500,30, see
on page 138
]ADEMod:SET
Sets demodulator
ADEM:PM AVER,MAXH,MINH, see
on page 134
TDOMain][:TYPE]
Selects the PM results to be measured
ADEM:AM:REL WRIT,OFF,OFF, see
AFSPectrum[:TYPE]
Selects the AM results to be measured
ADEM:PM:AFSP WRIT,OFF,OFF, see
AFSPectrum[:TYPE]
Selects the AF spectrum results of the demodulated PM signal
to be measured
ADEM ON, see
[SENSe:]ADEMod[:STATe]
Switches the demodulator on
INIT; WAI
Starts the measurement and waits for termination
FORM ASC, see
FORMat[:DATA]
Selects output format
ADEM:PM:RES? AVER, see
AFSPectrum:RESult
Reads PM average result data
ADEM:PM:RES? MAXH, see
AFSPectrum:RESult
Reads PM maxhold result data
ADEM:PM:RES? MINH, see
AFSPectrum:RESult
Reads PM minhold result data
ADEM:AM:RES? WRIT, see
AFSPectrum:RESult
Reads current AM result data
ADEM:PM:AFSP:RES? WRIT
Reads current AF spectrum result data of demodulated PM sig-
nal
ADEMOD
0 s to measurement time
*RST: 0 s
ADEM:PM:RPO 500us
Sets the position where the phase to 0 rad setting to 500 µs.
[SENSe:]ADEMod:PM[:
[SENSe:]ADEMod:FM:
on page 131
[SENSe:]ADEMod:PM:
on page 135
on page 121
on page 184
[SENSe:]ADEMod:PM:
on page 136
[SENSe:]ADEMod:PM:
on page 136
[SENSe:]ADEMod:PM:
on page 136
[SENSe:]ADEMod:PM:
on page 136
[SENSe:
137