Ethernet-Oam Period - Planet SGS-6341 Series Command Manual

no ethernet-oam mode
Function:
Configure the mode of OAM function, no command restores the default value.
Parameter:
active, active mode
passive, passive mode
Default:
active mode.
Command Mode:
Port mode
Usage Guide:
At least one of the two connected OAM entities should be configured to active mode. Once OAM is
enabled, the working mode of OAM cannot be changed and you need to disable OAM function if
you have to change the working mode.
Example:
Set the mode of OAM function on ethernet 1/0/4 to passive mode.
Switch(Config-If-Ethernet1/0/4)#ethernet-oam mode passive

11.21 ethernet-oam period

Command:
ethernet-oam period <seconds>
no ethernet-oam mode
Function:
Configure the transmission period of Information OAMPDU, no command restores the default value.
Parameter:
<seconds>, sending period, ranging from 1 to 2 seconds.
Default:
1s.
Command Mode:
Port mode
Usage Guide:
Use this command to configure the transmission interval of Information OAMPDU which keep OAM
connection normally.
11-34