Planet SGS-6341 Series Command Manual page 498

S –static
R - RIP derived
O - OSPF derived
A- OSPF ASE
B- BGP derived
Destination
Mask
Nexthop
Interface
Preference
32.4 show ip route vrf
Command:
show ip route vrf <name> [connected | static | rip| ospf | bgp | isis| kernel|statistics|
database[connected | static | rip| ospf | bgp | isis|kernel] ]
show ip route fib vrf <name> [default|main|local]
Function:
Show the routing tables entries.
Parameters:
<name> is the name of the forwarding instance of VPN route; <destination> is the destination
address; <destination>/<length> are the network address for the destination as well as the length
of the network mask; connected is for direct route; static is for static route; rip is for the RIP route
protocol; ospf is for the OSPF route protocol; bgp is for the BGP route protocol; isis is for the ISIS
route protocol; kernel is for the kernel route protocol; statistics are the number of route entries to
be displayed; database is for the route database; fib is for the core route table.
Command Mode:
all modes.
Usage Guide:
To display the contents of the VPN routing table, including routing type, destination network address,
address mask, the address and interface for the next hop, etc.
connected with the layer 3 switch
Static route, the route manually configured by
users
RIP route, acquired by layer 3 switch through the
RIP protocol.
OSPF route, acquired by layer 3 switch through the
OSPF protocol
Route introduced by OSPF
BGP route, acquired by the BGP protocol.
Target network
Target network mask
Next-hop IP address
Next-hop pass-by layer 3 swtich interfaces
Route priority. If other types of route to the target
network exists, the kernel route will only shows
those with high priority.
32-137