Switchport Port-Security Timeout - Planet SGS-6341 Series Command Manual

Usage Guide:
The MAC address binding function must be enabled before maximum secure MAC address number
can be set. If secure static MAC address number of the port is larger than the maximum secure
MAC address number set, the setting fails; extra secure static MAC addresses must be deleted, so
that the secure static MAC address number is no larger than the maximum secure MAC address
number for the setting to be successful.
Example:
Set the maximum secure MAC address number for port 1.
Switch(config)#interface Ethernet 1/0/1
Switch(Config-If-Ethernet1/0/1)# switchport port-security maximum 4

13.2.11 switchport port-security timeout

Command:
switchport port-security timeout <value>
no switchport port-security timeout
Function:
Set the timer for port locking; the "no switchport port-security timeout" command restores the
default setting.
Parameter:
< value> is the timeout value, the valid range is 0 to 300s.
Command mode:
Port Mode.
Default:
Port locking timer is not enabled by default.
Usage Guide:
The port locking timer function is a dynamic MAC address locking function. MAC address locking
and conversion of dynamic MAC entries to secure address entries will be performed on locking
timer timeout. The MAC address binding function must be enabled prior to running this command.
Example:
Set port1 locking timer to 30 seconds.
Switch(config)#interface Ethernet 1/0/1
Switch(Config-If-Ethernet1/0/1)# switchport port-security timeout 30
13-96