Planet SGS-6341 Series Command Manual page 751

ip pim bsr-candidate {vlan <vlan-id>| <ifname>} [hash-mask-length] [priority]
no ip pim bsr-candidate
Function:
This command is the candidate BSR configure command in global mode and is used to configure
PIM-SM information about candidate BSR in order to compete with other candidate BSRs for the
BSR router. The command "no ip pim bsr-candidate" disables the candidate BSR.
Parameter:
Ifname is the specified interface's name;
[hash-mask-length] is the specified hash mask length. It's used for the RP enable selection and
ranges from 0 to 32;
[priority] is the candidate BSR priority and ranges from 0 to 255. If this parameter is not configured,
the default priority value is 0.
Default:
This switch is not a candidate BSR router.
Command Mode:
Global Mode
Usage Guide:
This command is the candidate BSR configure command in global mode and is used to configure
PIM-SM information about candidate BSR in order to compete with other candidate BSRs for the
BSR router. Only this command is configured, this switch is the BSR candidate router.
Example:
Globally configure the interface vlan1 as the candidate BSR-message transmitting interface.
Switch (config)# ip pim bsr-candidate vlan1 30 10
44.3.15 ip pim cisco-register-checksum
Command:
ip pim cisco-register-checksum [group-list <simple-acl>]
no ip pim cisco-register-checksum [group-list <simple-acl>]
Function:
Configure the register packet's checksum of the group specified by myfilter to use the whole
packet's length.
Default:
Compute the checksum according to the register packet's head length, default: 8
Parameter:
<simple-acl>: <1-99> Simple access-list <simple-acl>: <1-99> Simple access-list
Command Mode:
44-27