Planet SGS-6341 Series Command Manual page 607

configuration to only configure tunnel carefully.
Example:
Switch#config terminal
Switch(config)#interface vlan 1
Switch(Config-if-Vlan1)#ipv6 router ospf area 1 tag IPI instance-id 1
36.24 max-concurrent-dd
Command:
max-concurrent-dd <value>
no max-concurrent-dd
Function:
Configure with this command the current dd max concurrent number in the OSPF processing. The
"no max-concurrent-dd" command restores the default.
Parameter:
<value> ranges between <1-65535>, the capacity of concurrent dd data packet processing.
Default:
No default configuration. No dd concurrent limit.
Command Mode:
OSPFv3 protocol mode
Usage Guide:
Specify the current dd max concurrent number in the OSPF processing.
Example:
Set the max concurrent dd to 20.
Switch#config terminal
Switch(config)#router ipv6 ospf
Switch(config-router)#max-concurrent-dd 20
36.25 passive-interface
Command:
[no] passive-interface {<ifname>|vlan <vlan-id>}
Function:
Configure that the hello group not sent on specific interfaces. The "no
passive-interface{<ifname>|vlan <vlan-id>}" command cancels this function.
36-246