Planet SGS-6341 Series Command Manual page 711

destination address of packets is an interface address to ensure that packets can be returned along
the original paths. There is no special request for UDP data.
Example:
Configure source address of bfd echo packets to 192.168.1.1.
s5(config)#bfd echo-source-ip 192.168.1.1
41.6 bfd echo-source-ipv6
Command:
bfd echo-source-ipv6 <ipv6-address>
no bfd echo-source-ipv6
Function:
Detect link fault by configuring source address of echo packets, no command deletes the configured
source address of echo packets.
Parameter:
<ipv6-address> is IPv6 address, the validity of parameter should be ensured by users and do not
check the validity of address.
Default:
No source address of echo packets is configured.
Command mode:
Global mode
Usage Guide:
It needs to configure source address of Echo packets when BFD echo detects IPv6 link fault. The
configuration for source address is optional, it just avoids ICMPv6 redirect packets to be sent. The
destination address of packets is an interface address to ensure that packets can be returned along
the original paths. There is no special request for UDP data.
Example:
Configure source address of bfd echo packets to 2000::1.
s5(config)#bfd echo-source-ipv6 2000::1
41.7 bfd enable
Command:
bfd enable
no bfd enable
41-4