Planet SGS-6341 Series Command Manual page 904

Usage Guide:
The command is only working under global IPv6 multicast destination-control enabled, after
configuring the command, if MLD-SPOOPING or MLD is enabled, for adding the members to
multicast group. If configuring multicast destination-control on specified net segment of transmitted
MLD-REPORT, and match configured access-list, such as matching permit, the interface can be
added, otherwise do not be added. If relevant group or source in show ipv6 mld groups detail has
been established before executing the command, it needs to execute clear ipv6 mld group
command to clear relevant groups in admin mode.
Example:
Switch(config)#ipv6 multicast destination-control 2008::8/64 access-group 9000
45.6.5 ipv6 multicast destination-control access-group
(vmac)
Command:
ipv6 multicast destination-control <1-4094> <macaddr> access-group <9000-10999>
no ipv6 multicast destination-control <1-4094> <macaddr> access-group <9000-10999>
Function:
Configure the IPv6 multicast destination access list used by the specified vlan-mac, the no
operation of this command will delete this configuration.
Parameters:
<1-4094>: VLAN-ID;
<macaddr>: The source MAC address sending of the MLD-REPORT, the format of which
is"xx-xx-xx-xx-xx-xx".
<9000-10999>: Destination access list number.
Default:
Not configured.
Command Mode:
Global Configuration Mode.
Usage Guide:
This command can only take effect when the IPv6 multicast destination control is globally enabled,
after configuring this command, if the MLD-SNOOPING is enabled, when adding the port to the
multicast group, it will be matched according to the configured access list. Only when the port is
matched as permit, will it be added, or it can not be added.
Example:
switch(config)#ipv6 multicast destination-control 1 00-01-03-05-07-09 access-group 9000
45-50