Planet SGS-6341 Series Command Manual page 717

41.15 ipv6 ospf bfd enable instance-id
Command:
ipv6 ospf bfd enable instance-id <0-255>
no ipv6 ospf bfd enable
Function:
Configure BFD for OSPFv3 instance on the specific interface, no command cancels the
configuration.
Default:
BFD is no enabled for OSPFv3 instance.
Command Mode:
Interface configuration mode
Usage Guide:
Configure BFD for OSPFv3 instance on the specific interface which enable OSPFv3 protocol, BFD
will inform OSPFv3 after detect link fault and OSPFv3 will deal with it in best times.
Example:
Enable BFD for OSPFv3 on interface.
s5(config-if-vlan50)#ipv ospf bfd enable instance-id 254
41.16 ipv6 rip bfd enable
Command:
ipv6 rip bfd enable
no ipv6 rip bfd enable
Function:
Configure BFD for RIPng protocol on the specific interface, no command cancels the configuration.
Default:
BFD is not enabled for RIPng.
Command Mode:
Interface configuration mode
Usage Guide:
Enable BFD for RIPng protocol, after that, if this interface has received RIPng packets, RIPng will
inform BFD to set remote ip as session and detect the state in order to inform RIPng in time.
Example:
Enable BFD for RIPng.
s5(config-if-vlan50)#ipv6 rip bfd enable
41-10