Planet SGS-6341 Series Command Manual page 972

authenticated exceeds the number of allowed user, additional users will not be able to access the
network.
Example:
Setting port 1/0/3 to allow 5 users.
Switch(Config-If-Ethernet1/0/3)#dot1x max-user macbased 5
48.13 dot1x max-user userbased
Command:
dot1x max-user userbased <number>
no dot1x max-user userbased
Function:
Set the upper limit of the number of users allowed access the specified port when using user-based
access control mode; the no command is used to reset the default value.
Parameters:
<number> the maximum number of users allowed to access the network, ranging from 1 to 1~256.
Command Mode:
Port Mode.
Default Settings:
The maximum number of users allowed to access each port is 10 by default.
User Guide:
This command can only take effect when the port adopts user-based access control mode. If the
number of authenticated users exceeds the upper limit of the number of users allowed access the
network, those extra users can not access the network.
Examples:
Setting port 1/0/3 to allow 5 users.
Switch(Config-If-Ethernet1/0/3)#dot1x max-user userbased 5
48.14 dot1x port-control
Command:
dot1x port-control {auto | force-authorized | force-unauthorized}
no dot1x port-control
Function:
Sets the 802.1x authentication status; the "no dot1x port-control" command restores the default
48-9