Planet SGS-6341 Series Command Manual page 451

Function:
This command is use to enable the DHCP snooping debug switch to debug the communication
information between DHCP snooping and helper server.
Command Mode:
Admin Mode.
Usage Guide:
Debug the information of communication messages received and sent by DHCP snooping and
helper server.
30.6 enable trustview key
Command:
enable trustview key {0 | 7} <password>
no enable trustview key
Function:
To configure DES encrypted key for private packets, this command is also the switch for the private
packets encrypt and hash function enabled or not.
Parameter:
<password> is character string length less than 16, which use as encrypted key. 0 for un-encrypted
text for the password, while 7 for encrypted.
Command Mode:
Global Mode.
Default:
Disabled.
Usage Guide:
The switch communicates with the TrustView management system through private protocols. By
default these packets are not encrypted. In order to prevent spoofing, it can be configured to encrypt
these packets. And at the same time, the same password should be configured on TrustView
server.
Example:
Enable encrypt or hash function of private message.
Switch(config)# enable trustview key 0 digitalchina
30-90