Planet SGS-6341 Series Command Manual page 356

Switch#show urpf
19.4.2 urpf enable
Command:
urpf enable
no urpf enable
Function:
Enable the global URPF function.
Command mode:
Global Mode
Default:
The URPF protocol module is disabled by default.
Example:
Switch(config)#urpf enable
19.5 Commands for ARP Configuration
19.5.1 arp
Command:
arp <ip_address> <mac_address> {interface [ethernet] <portName>}
no arp <ip_address>
Function:
Configures a static ARP entry; the "no arp <ip_address>" command deletes a ARP entry of the
specified IP address.
Parameters:
<ip_address> is the IP address, at the same field with interface address; <mac_address> is the
MAC address; ethernet stands for Ethernet port; <portName> for the name of layer2 port.
Default:
No static ARP entry is set by default.
Command mode:
VLAN Interface Mode
Usage Guide:
19-202