Planet SGS-6341 Series Command Manual page 738

Switch (config)#show ip pim neighbor
Switch (config)#
44.2.12 ip pim scope-border
Command:
ip pim scope-border [<1-99 >|<acl_name>]
no ip pim scope-border
Function:
To configure or delete management border of PIM.
Parameters:
<1-99 >: is the ACL number for the management border.
<acl_name>: is the ACL name for the management border.
Default:
Not management border. If no ACL is specified, the default management border will be used.
Command Mode:
Interface Configuration Mode.
Usage Guide:
To configure the management border and the ACL for the PIM protocol. The multicast data flow will
not be forwarded to the SCOPE-BORDER.
Example:
Switch(Config-if-Vlan2)#ip pim scope-border 3
44.2.13 ip pim state-refresh origination-interval
Command:
ip pim state-refresh origination-interval <interval>
no ip pim state-refresh origination-interval
Function:
Configure transmission interval of state-refresh message. The "no ip pim state-refresh
origination-interval" command restores default value.
Parameter:
<interval> packet transmission interval value is from 4s to 100s.
Default:
60s
Command Mode:
44-14