Planet SGS-6341 Series Command Manual page 353

Example:
Configure tunnel source IPv4 address 202.89.176.6.
Switch(Config-if-Tunnel1)#tunnel source 202.89.176.6
19.2.39 tunnel destination
Command: .
tunnel destination <ipaddress | ipv6address>
no tunnel destination
Function:
Configure the IPv4/IPv6 address of the tunnel destination.
Parameter:
<ipaddress> is the IPv4 address of tunnel destination, <ipv6address> is the IPv6 address of
tunnel destination.
Command Mode:
Tunnel Configuration Mode.
Default Situation:
There is no IPv4/IPv6 address of tunnel destination.
Usage Guide:
This command is used to configure the IPv4/IPv6 address of tunnel destination.
Example:
Configure tunnel destination 203.78.120.5.
Switch(Config-if-Tunnel1)#tunnel destination 203.78.120.5
19.2.40 tunnel nexthop
Command:
tunnel nexthop <ipaddress>
no tunnel nexthop
Function:
Configure tunnel next hop.
Parameter:
<ipaddress> is the ipv4 address of tunnel next hop.
Command Mode:
Tunnel Configuration Mode.
Default Situation:
19-199