Planet SGS-6341 Series Command Manual page 897

ifname: the specified name of the interface.
A:B::C:D/M: the ip prefix and mask.
<priority>: the priority of RP election, ranging from 0 to 255, the default value is 192, the smaller
the value is the higher the priority is.
Command Mode:
Global Configuration Mode.
Default Setting:
No RP interface is configured by default.
Usage Guide:
In order to support ANYCAST RP function, new rule allows configuring a Loopback interface to be
the RP candidate interface, the RP candidate interface should be currently unique, and the address
of which should be added into the router to make sure that PIM router can find the nearest RP. The
"no ipv6 pim rp-candidate" command can be used to cancel the RP candidate.
Example:
Configure Loopback1 interface as the RP candidate interface in global configuration mode.
Switch(config)# ipv6 pim rp-candidate loopback1
45.4.6 show debugging ipv6 pim
Command:
show debugging ipv6 pim
Command Mode:
Admin and Configuration Mode.
Usage Guide:
The current state of ANYCAST RP debug switch.
Example:
Switch(config)#show debugging ipv6 pim
Debugging status:
PIM anycast-rp debugging is on
45.4.7 show ipv6 pim anycast-rp first-hop
Command:
show ipv6 pim anycast-rp first-hop
Command Mode:
45-43