Planet SGS-6341 Series Command Manual page 510

ip rip authentication mode
33.16 ip rip authentication cisco-compatible
Command:
ip rip authentication cisco-compatible
no ip rip authentication cisco-compatible
Function:
After configured this command, the cisco RIP packets will be receivable by configuring the plaintext
authentication or MD5 authentication.
Default:
Not configured
Command Mode:
Interface mode
Usage Guide:
After authentication is configured on the cisco router, the RIP packets will exceeds the length of the
defined standard length of the protocol once the number of route items is greater than 25. By
configuring this command the over-lengthen RIP packets will be receivable other than denied.
Example:
Switch# config terminal
Switch(config)# interface vlan 1
Switch(Config-if-Vlan1)# ip rip authentication cisco-compatible
Related Command:
ip rip authentication mode
33.17 ip rip receive-packet
Command:
ip rip receive-packet
no ip rip receive-packet
Function:
Set the interface to be able to receivable RIP packets; the "no ip rip receive-packet" command set
the interface to be unable to receivable RIP packets.
Default:
Interface receives RIP packets.
Command Mode:
33-149