Planet SGS-6341 Series Command Manual page 477

Parameter:
"<interface-name >"is the name of the interface.
Command Mode:
route-map mode
Usage Guide:
This command matches according to the next-hop messages in the route.
succeeded, then the "permit" or "deny" action in the route-map is performed. This command is only
used in RIP and OSPF protocols.
Example:
Switch#config terminal
Switch(config)#route-map r1 permit 5
Switch(config-route-map)#match interface vlan1
31.7 match ip
Command:
match ip <address | next-hop> <ip-acl -name | ip-acl -num | prefix-list list-name>
no match ip <address | next-hop> [<ip-acl -name | ip-acl -num | prefix-list list-name>]
Function:
Configure the routing prefix or next-hop. The "no match ip <address | next-hop> [<ip-acl -name |
ip-acl -num | prefix-list list-name>]" deletes this configuration.
Parameter:
<address > means matching the routing prefix, <next-hop>means matching the routing next-hop,
<ip-acl -name > is the name of ip access-list, <ip-acl -num > is the ip access-list sequence number,
ranging between 1～199 or 1300～2699 (extension scope), prefix-list means the matching should
follow the prefix-list rules, list-name is the name of prefix-list.
Command Mode:
route-map mode
Usage Guide:
This command matches according to the next-hop messages or routing prefix in the route. If the
matching succeeded, then the "permit" or "deny" action in the route-map is performed.
Example:
Switch#config terminal
Switch(config)#route-map r1 permit 5
Switch(config-route-map)#match ip address prefix-list mylist
31-116
If the matching