Planet SGS-6341 Series Command Manual page 989

Vlan
-----------------------------------------------------------------------------------------------------
1
-----------------------------------------------------------------------------------------------------
49.12 show nd-dynamic count
Command:
show nd-dynamic count {(vlan <1-4096>)| interface ethernet <portName>}
Function:
Display the number of dynamic ND of corresponding port and VLAN.
Parameters:
<vlan-id> is play the specified vlan ID. <portName> is the name of layer-2 port.
Command Mode:
Admin and Configuration Mode.
Usage Guide:
Use this command to display the number of dynamic ND of corresponding port and VLAN.
Examples:
Display the number of dynamic ND of the port and VLAN which are configured with number
limitation function of ND.
Switch(config)# show nd-dynamic count interface ethernet 1/0/3
Port
-----------------------------------------------------------------------------------------------------
Ethernet1/0/3
-----------------------------------------------------------------------------------------------------
Switch(config)# show nd-dynamic count vlan 1
Vlan
-----------------------------------------------------------------------------------------------------
1
-----------------------------------------------------------------------------------------------------
49.13 switchport arp dynamic maximum
Command:
switchport arp dynamic maximum <value>
MaxCount
55 15
MaxCount
5
MaxCount
55 15
CurrentCount
CurrentCount
1
CurrentCount
49-8