Planet SGS-6341 Series Command Manual page 414

27.20 network-address
Command:
network-address <ipv6-pool-start-address> {<ipv6-pool-end-address> | <prefix-length>}
[eui-64]
no network-address
Function:
To configure the DHCPv6 address pool; the no form of this command will remove the address pool
configuration.
Parameters:
<ipv6-pool-start-adderss> is the start of the address pool; <ipv6-pool-end-address> is the end of
the address pool; <prefix-length> is the length of the address prefix, which is allowed to be
between 3 and 128, and 64 by default, the size of the pool will be determined by <prefix-length> if
it has been specified. <ipv6-pool-end-address> and <prefix-length> alternative options to
determine the size of the IPv6 address pool. If <prefix-length> is 64 and the eui-64 option has
been configured, the DHCPv6 server will allocate IPv6 addresses according to the EUI-64 standard,
or the DHCPv6 server will be allocating addresses sequentially.
Default:
No address pool is configured by default.
Command Mode:
DHCPv6 Address Pool Configuration Mode.
Usage Guide:
This command configures the address pool for the DHCPv6 server to allocate addresses, only one
address range can be configured for each address pool. To be noticed, if the DHCPv6 server has
been enabled, and the length of the IPv6 address prefix has been configured, the length of the
prefix in the address pool should be no less than the length of the prefix of the IPv6 address of the
respective layer three interfaces in the switch. If <ipv6-pool-end-address> is bigger than
<ipv6-pool-start-address>, this command returns at once.
Example:
To configure the address range for address pool as 2001:da8:123::100-2001:da8:123::200.
Switch(dhcp-1-config)#network-address 2001:da8:123::100 2001:da8:123::200
Relative Command:
excluded-address
27-53