Planet SGS-6341 Series Command Manual page 594

advertise: Advertise this area
not-advertise : Not advertise this area
If both are not set, this area is defaulted for advertising
Default:
Function not configured.
Command Mode:
OSPFv3 protocol mode
Usage Guide:
Use this command to aggregate routes inside an area. If the network IDs in this area are not
configured continuously, a summary route can be advertised by configuring this command on ABR.
This route consists of all single networks belong to specific range.
Example:
Switch # config terminal
Switch (config)# router ipv6 ospf
Switch (config-router)# area 1 range 2000::/3
36.3 area stub
Command:
area <id> stub [no-summary]
no area <id> stub [no-summary]
Function:
Define a area to a stub area. The "no area <id> stub [no-summary]" command cancels this
function.
Parameter:
<id> is the area number which could be digits ranging between 0～4294967295, and also as an
IPv4 address.
no-summary:
The area border routes stop sending link summary announcement to the stub area
Default:
Not defined
Command Mode:
OSPFv3 protocol mode
Usage Guide:
Configure area stub on all routes in the stub area. There are two configuration commands for the
routers in the stub area: stub and default-cost. All routers connected to the stub area should be
configured with area stub command. As for area border routers connected to the stub area, their
36-233