Planet SGS-6341 Series Command Manual page 445

29.1.20 remote-id subscriber-id
Command:
{remote-id [*] <remote-id> [*] | subscriber-id [*] <subscriber-id> [*]}
no {remote-id [*] <remote-id> [*] | subscriber-id [*] < subscriber-id> [*]}
Function:
This command configures option 37 and option 38 that match the class in IPv6 DHCP class
configuration mode.
Parameters:
<remote-id>, a string with a length ranging from 1 to 128 bytes is used to match remote-id in option
37.
<subscriber-id>, a string with a length ranging from 1 to 128 bytes is used to match subscriber-id in
option 38.
[*], match zero or more characters.
Command Mode:
IPv6 DHCP Class configuration mode
Usage Guide:
This command configures a mode which matches with the already-defined DHCPv6 class, and a
DHCPv6 class may configure multiple commands. If this command is ignored and no mode
configured in IPv6 DHCP Class mode, any remote-id or subscriber-id is considered to match with
the DHCPv6 class, however, remote-id or subscriber-id must exist in DHCPv6 packet.
Example:
Configure some remote-id or subscriber-id belonging to DHCPv6 class named CLASS1.
Switch(Config)# ipv6 dhcp class CLASS1
Switch(Dhcpv6-class)#remote-id abc* subscriber-id bcd*
Switch(Dhcpv6-class)#remote-id edf*
Switch(Dhcpv6-class)#subscriber *mmn
29.2 Commands for Monitoring and Debugging
29.2.1 debug ipv6 dhcp detail
Command:
debug ipv6 dhcp detail
Function:
Display the debug about detailed content of various packets sent and received by DHCPv6. If
packets with option 37 and option 38, they will also be displayed. This command is applied in the
29-84