Planet SGS-6341 Series Command Manual page 444

(sp | sv | pv | spv), a selection from combinations of slot, port and vlan, among which sp represents
slot and port, sv represents slot and vlan, pv represents port and vlan, and spv represents slot, port
and vlan.
WORD, the delimiter between slot, port and vlan which ranges among (#|.|,|;|:|/|space). Note that
there're two delimiter WORDs here, of which the former is the delimiter between slot and port while
the latter is that between port and vlan.
Command Mode:
Global configuration mode
Usage Guide:
This command has no effect on ports with self-defined subscriber-id. If a user redefines
subscriber-id of the port after configuring the command, the user-defined one prevails. This
configuration is null by default.
Example:
Swithc(config)# ipv6 dhcp snooping subscriber-id select sv delimiter #
29.1.19 ipv6 dhcp use class
Command:
ipv6 dhcp use class
no ipv6 dhcp use class
Function:
This command enables DHCPv6 server to support DHCPv6 class during address assignment, the
no operation of this command disables it without removing the relative DHCPv6 class information
that has been configured.
Default:
DHCPv6 server supports DHCPv6 class during address assignment.
Command Mode:
Global configuration mode
Usage Guide:
By default, DHCPv6 servers support DHCPv6 class during address assignment and the no form of
this command doesn't remove DHCPv6 class information that has been configured. Make sure that
DHCPv6 service has been enabled before using this command. DHCPv6 server supports DHCPv6
class during address assignment by default.
Example:
Configure DHCPv6 server to support DHCPv6 class during address assignment.
Switch(Config)# ipv6 dhcp use class
29-83