Planet SGS-6341 Series Command Manual page 596

any two backbone areas routers connected with the public non-backbone area. The protocol treat
routers connected by virtual links as a point-to-point network.
Example:
Switch#config terminal
Switch(config) #router ipv6 ospf
Switch(config-router) #area 1 virtual-link 10.10.11.50 hello 5 dead 20
Switch(config-router) #area 1 virtual-link 10.10.11.50 instance-id 1
36.5 abr-type
Command:
abr-type {cisco|ibm| standard}
no abr-type [cisco|ibm| standard]
Function:
Configure an OSPF ABR type with this command. The "no abr-type [cisco|ibm| standard]"
command restores the default.
Parameter:
cisco, realize by cisco ABR; ibm, realize by ibm ABR; shortcut, specify a shortcut-ABR; standard,
realize with standard（RFC2328）ABR.
Default:
Cisco configured by default
Command Mode:
OSPFv3 protocol mode
Usage Guide:
For Specifying the realizing type of abr. This command is good for interactive operation among
different OSPF realizing method and is especially useful in the multiple host environment.
Example:
Switch#config terminal
Switch(config)#router ipv6 ospf
Switch(config-router)#abr-type standard
36.6 default-metric
Command:
default-metric <value>
36-235