Planet SGS-6341 Series Command Manual page 486

Switch(config)#route-map r1 permit 10
Switch(config-route-map)#set extcommunity soo 200.200:10
31.21 set ip next-hop
Command:
set ip next-hop <ip_addr>
no set ip next-hop [<ip_addr>]
Function:
Configure the next-hop of the route. The "no set ip next-hop [<ip_addr>]" command deletes the
configuration.
Parameter:
<ip_addr > is the ip address of next-hop shown with dotted decimal notation.
Command Mode:
route-map mode
Example:
Switch#config terminal
Switch(config)#route-map r1 permit 5
Switch(config-route-map)#set ip next-hop 10.2.2.2
31.22 set local-preference
Command:
set local-preference <pre_val>
no set local-preference [<pre_val>]
Function:
Configure the local priority of BGP route. The "no set local-preference [<pre_val>]" command
deletes this configuration.
Parameter:
<pre_val > is the value of local priority, ranging between 0～4294967295.
Command Mode:
route-map mode
Usage Guide:
The local priority attribute is the priority level of a route. A route with a higher local priority level when
compared with other route of the same destination, will be more preferred than other route. The
31-125