Planet SGS-6341 Series Command Manual page 782

Switch(router-msdp-peer)# remote-as 20
44.4.25 router msdp
Command:
router msdp
no router msdp
Function:
Enable the MSDP protocol of the switch, enter MSDP mode; the no form command disable MSDP
protocol.
Command Mode:
Global Mode.
Default:
Disabled.
Usage Guide:
Enable MSDP on global mode, but even configured PIM SM at the same time, then the MSDP can
be work.
Example:
Enable MSDP on global mode.
Switch(config)#router msdp
44.4.26 sa-filter
Command:
sa-filter {in | out} [ list <acl-number | acl-name> | rp-list <rp-acl-number | rp-acl-name>]
no sa-filter {in | out} [ list <acl-number| acl-name> | rp-list <rp-acl-number | rp-acl-name>]
Function:
To configure the filter policy of receiving or transmitting messages, which can be used to controls
the receiving and transmitting source message.
Parameter:
in: To filter the SA messages from specified MSDP Peer.
out: To filter the SA messages transmitted from specified MSDP Peer.
acl-number: Specified advanced ACL number (100-199).
acl-name: Specified advanced ACL name.
rp-acl-number: Specified standard ACL number (1-99).
rp-acl-name: Specified standard ACL name.
44-58