Planet SGS-6341 Series Command Manual page 905

45.6.6 ipv6 multicast policy
Command:
ipv6 multicast policy <IPADDRSRC/M> <IPADDRGRP/M> cos <priority>
no ipv6 multicast policy <IPADDRSRC/M> <IPADDRGRP/M> cos
Function:
Configure IPv6 policy multicast, the no operation of this command is to cancel the policy multicast of
IPv6.
Parameters:
<IPADDRSRC/M>: The source address and the length of the mask of IPv6 multicast.
<IPADDRGRP/M>: The multicast address of IPv6 and the length of mask of multicast address
<priority>: The specified priority, the range of which is <0-7>.
Default:
Not configured.
Command Mode:
Global Configuration Mode.
Usage Guide:
Using this command to configure can change the priority of the multicast data which is confined by
the act of matching of this switch to a specified value, and set the TOS to the same value
simultaneously. Please pay attention to that, for the messages sent in UNTAG mode, their priority
will not be changed.
Example:
Switch(config)#ipv6 multicast policy 2008::1/64 ff1e::3/64 cos 4
45.6.7 ipv6 multicast source-control
Command:
ipv6 multicast source-control
no ipv6 multicast source-control
Function:
Configure to globally enable IPv6 multicast source control, the no operation of this command is to
recover and globally disable the IPv6 multicast source control.
Default:
Disabled.
Command Mode:
45-51