Planet SGS-6341 Series Command Manual page 863

45.2.12 ipv6 pim scope-border
Command:
ipv6 pim scope-border [<500-599>|<acl_name>]
no ipv6 pim scope-border
Function:
To configure or delete management border of PIM6.
Parameters:
<500-599> is the ACL number for the management border.
<acl_name> is the ACL name for the management border.
Default:
Not management border. If no ACL is specified, the default management border will be used.
Command Mode:
Interface Configuration Mode.
Usage Guide:
To configure the management border and the ACL for the IPV6 PIM. The multicast data flow will not
be forwarded to the SCOPE-BORDER.
Example:
Switch(Config-if-Vlan2)#ipv6 pim scope-border 503
45.2.13 ipv6 pim state-refresh origination-interval
Command:
ipv6 pim state-refresh origination-interval <interval>
no ipv6 pim state-refresh origination-interval
Function:
Configure transmission interval of state-refresh message on interface. The "no ipv6 pim
state-refresh origination-interval" command restores default value.
Parameter:
<interval> message transmission interval value is from 4s to 100s.
Default:
60s
Usage Guide:
The first-hop router periodically transmits stat-refresh messages to maintain PIM-DM list ltems of all
the downstream routers. The command can modify origination interval of state-refresh messages.
Usually do not modify relevant timer interval. The command can configure on IPv6 tunnel interface,
but it is successful configuration to only configure tunnel carefully.
45-9