Planet SGS-6341 Series Command Manual page 882

tunnel carefully.
Example:
Configure VLAN's pim neighbor access-list.
Switch (Config-if-Vlan1)#ipv6 pim neighbor-filter myfilter
Switch(config)#ipv6 access-list standard myfilter
Switch(config_IPv6_Std-Nacl-myfilter)#deny fe80:20e:cff:fe01:facc
Switch(config)#ipv6 access-list standard myfilter
Switch(config_IPv6_Std-Nacl-myfilter)#permit any
45.3.24 ipv6 pim register-rate-limit
Command:
ipv6 pim Register-rate-limit <limit>
no ipv6 pim Register-rate-limit
Function:
This command is used to configure the speedrate of DR sending register packets, the unit is
packet/second. The "no ipv6 pim Register-rate-limit" command restores the default value. This
configured speedrate is each（S, G）state's, not the whole systems.
Parameter:
<limit> ranges from 1 to 65535
Default:
No limit for sending speed
Command Mode:
Global Mode
Usage Guide:
Configure the speedrate of DR sending register packets.
Example:
Configure the speedrate of DR sending register packets to 59p/s.
Switch(config)#ipv6 pim Register-rate-limit 59
45.3.25 ipv6 pim register-rp-reachability
Command:
ipv6 pim Register-rp-reachability
no ipv6 pim Register-rp-reachability
Function:
45-28