Planet SGS-6341 Series Command Manual page 630

command cancels this configuration.
Parameter:
ipv4-unicast: Configure the default using IPv4-unicast to set up neighbor connection.
local-preference<0-4294967295>: Configure the default local priority.
Default:
The IPv4 unicast is default enabled when BGP is enabled. The default priority is 100.
Command Mode:
BGP route mode.
Usage Guide:
IPv4 unicast address-family is default enabled in BGP. Cancel this setting with no bgp default
ipv4-unicast command so to not enable this address-family in default. Default local priority can be
configured through bgp default local-preference command.
Example:
Configure the default local priority to be 500.
Configure in 10.1.1.66:
Switch(config)#router bgp 200
Switch(config-router)# bgp default local-preference 500
37.16 bgp deterministic-med
Command:
bgp deterministic-med
no bgp deterministic-med
Function:
Use the best MED for the same prefix in the AS to compare with other AS. The "no bgp
deterministic-med" cancels this configuration.
Default:
Not configured.
Command Mode:
BGP route mode
Usage Guide:
Normally if same prefix routes from several paths, each path will be compared. With this
configuration, the system will only use the path with the smallest MED in the AS (when other main
attributes equal) to compare with other AS. After the best one is elected, select the path among AS
with no regard to MED value.
Example:
37-269