Planet SGS-6341 Series Command Manual page 283

Parameters:
policer_name: the name of aggregation policy;
bits_per_second: the committed information rate - CIR , in Kbps, ranging from 1 to 10000000;
normal_burst_bytes: the committed burst size – CBS, in kb, ranging from 1 to 1000000. When the
configured CBS value exceeds the max limit of the chip, configure the hardware with max number
supported by the chip without any CLI prompt;
maximum_burst_bytes: the peak burst size - PBS, in kb, ranging from 1to 1000000. When the
configured PBS value exceeds the max limit of the chip, configure the hardware with max number
supported by the chip without any CLI prompt. Notice: this configuration only exists in dual bucket
mode;
pir peak_rate_bps: the peak information rate - PIR, in kbps, ranging from 1to 10000000. Without
configuring PIR, the Police works in the single rate dual bucket mode; otherwise in the dual rate dual
bucket mode. Notice: this configuration only exist in the dual bucket mode.
exceed-action: the actions to take when the CIR is exceeded but PIR isn't, which means the
messages are yellow, the default is Drop;
violate-action: the actions to take when the PIR is exceeded, which means the messages are red,
the default is Drop.
ACTION:
drop/transmit: Drop/transmit the packets
set-internal-priority <intp_value>: Modify the internal priority of the packets
policied-intp-transmit: Drop the internal priority according to INT-PRIO_TO_INT-PRIO mapping
Default:
No aggregation Policy is defined by default; the default action of exceed-action and violate-action
both is drop.
Command mode:
Global Mode
Usage Guide:
The CLI can support both singe bucket and dual bucket configuration, and determine which one by
checking whether PIR or PBS is configured. When configuring with CLI, after configuring CBS, if the
action is directly configured, the mode is single rate single bucket; if only PBS is configured, the
mode is single rate dual bucket three colors; if PIR and PBS are configured, the mode is dual rate
dual bucket three colors. The actions of set and policy selected by policy map are same, the action
of policy can cover the action of the set. Furthermore, If the actions of exceed-action and
violate-action are set-internal-priority in policy, <intp_value> must be same.
Example:
Set the dual bucket mode, CIR is 1000, CBS is 1000, PIR is 20000, PBS is 10000. The action is
policed-intp-transmit when CIR is exceeded but PIR isn't, which means the messages are yellow.
Switch(config)#mls qos aggregate-policy color 10000 1000 20000 10000 exceed-action
15-129