Port-Rate-Statistics Interval; Port-Scan-Mode - Planet SGS-6341 Series Command Manual

Usage Guide:
This command applies to 1000Base-FX interface only. The negotiation command is not available for 1000Base-TX
or 100Base-TX interface. For combo port, this command applies to the 1000Base-FX port only but has no effect on
the 1000Base-TX port. To change the negotiation mode, speed and duplex mode of 1000Base-TX port, use
speed-duplex command instead.
Example:
Port 1 of Switch1 is connected to port 1 of Switch2, the following will disable the negotiation for both ports.
Switch1(config)#interface ethernet1/0/1
Switch1(Config-If-Ethernet1/0/1)#negotiation off
Switch2(config)#interface ethernet1/0/1
Switch2(Config-If-Ethernet1/0/1)#negotiation off

4.1.10 port-rate-statistics interval

Command:
port-rate-statistics interval [<interval-value>]
Function:
Set the interval of port-rate-statistics, ranging from 5 to 600.
Parameters:
interval-value: The interval of port-rate-statistics, unit is second, ranging from 5 to 600 with the configuration step of
5.
Command mode:
Global Mode.
Default:
Only port-rate-statistics of 5 seconds and 5 minutes are displayed.
Example:
Count the interval of port-rate-statistics as 20 seconds.
Switch(config)# port-rate-statistics interval 20

4.1.11 port-scan-mode

Command:
port-scan-mode {interrupt | poll}
no port-scan-mode
Function:
Configure the scan mode of the port as "interrupt" or "poll", the no command restores the default scan mode.
4-131
SGS-6341 Series Command Guide