Debug Rip - Planet SGS-6341 Series Command Manual

<A.B.C.D/M> Clear the routes which match the destination address from the RIP route table.
specifies the IP address prefix and its length of the destination address
kernel delete kernel routes from the RIP route table
static delete static routes from the RIP route table
connected delete direct routes from the RIP route table
rip only delete RIP routes from the RIP route table
ospf only delete OSPF routes from the RIP route table
isis only delete ISIS routes from the RIP route table
bgp only delete BGP routes from the RIP route table
all delete all routes from the RIP route table
Default:
No default configurations.
Command Mode:
Admin mode
Usage Guide:
Use this command with the all parameter will delete all learnt route in the RIP route which will be
immediately recovered except for rip route. The dynamic learnt RIP route can only be recovered by
studying one more time.
Example:
Switch# clear ip rip route 10.0.0.0/8
Switch# clear ip rip route ospf

33.4 debug rip

Command:
debug rip [events| nsm| packet[recv|send][detail]| all]
no debug rip [events| nsm| packet[recv|send][detail]| all]
Function:
Open various RIP adjustment switches and show various adjustment debugging messages. The
"no debug rip [events| nsm| packet[recv|send][detail]| all]" command close corresponding
debugging switch.
Parameter:
events shows the debugging messages of RIP events
nsm shows the communication messages between RIP and NSM
packet shows the debugging messages of RIP data packets
recv shows the messages of the received data packets
send shows the messages of the sent data packets
33-141