Planet SGS-6341 Series Command Manual page 973

setting.
Parameters:
auto enable 802.1x authentication, the port authorization status is determined by the authentication
information between the switch and the supplicant;
status, unauthenticated data is allowed to pass through the port; force-unauthorized will set the
port to non-authorized mode, the switch will not provide authentication for the supplicant and
prohibit data from passing through the port.
Command mode:
Port configuration Mode
Default:
When 802.1x is enabled for the port, auto is set by default.
Usage Guide:
If the port needs to provide 802.1x authentication for the user, the port authentication mode should
be set to auto.
Example:
Setting port1/0/1 to require 802.1x authentication mode.
Switch(config)#interface ethernet 1/0/1
Switch(Config-If-Ethernet1/0/1)#dot1x port-control auto
48.15 dot1x port-method
Command:
dot1x port-method {macbased | portbased | userbased {standard | advanced}}
no dot1x port-method
Function:
To configure the access control method of appointed interface. The no form command restores the
default access control method.
Parameter:
macbased means the access control method based on MAC address
portbased means the access control method based on port
userbased means the access control method based on user, it can be divided into two types, one is
standard access control method, and the other is advanced access control method
Command mode:
Port Configuration Mode.
Default:
Advanced access control method based on user is used by default.
Usage Guide:
force-authorized sets port to authorized
48-10