Planet SGS-6341 Series Command Manual page 541

Function:
Make sure the interface and line protocols is up.
Command Mode:
Admin mode
Example:
Switch(config)#show ipv6 rip interface
Loopback is up, line protocol is up
RIPng is not enabled on this interface
Vlan1 is up, line protocol is up
Routing Protocol: RIPng
Passive interface: Disabled
Split horizon: Enabled with Poisoned Reversed
IPv6 interface address:
3000:1:1::1/64
fe80::203:fff:fe0c:cda/64
Displayed information
Vlan1 is up, line protocol is up
Routing Protocol: RIP
Passive interface: Disabled
Split horizon: Enabled with Poisoned Reversed
IP interface address:
3000:1:1::1/64
fe80::203:fff:fe01:429e/64
34.21 show ipv6 rip redistribute
Command:
show ipv6 rip redistribute
Function:
Show the configuration information of redistributed other out routing to RIPng.
Default:
Not shown by default.
Command Mode:
Admin Mode and Configuration Mode.
Explanations
Interface is Up
The routing protocol running on the interface is
RIPng
Passive-interface disabled
The split horizon is enabled with poisoned
reversed on the interface.
IPv6 address of the interface
34-180