Planet SGS-6341 Series Command Manual page 808

Any Configuration Mode
Usage Guide:
The command applies to display DVMRP routing table item; DVMRP maintains individual unicast
routing table to check RPF.
Example:
Display DVMRP routiing.
Switch #show ip dvmrp route
Flags: N = New, D = DirectlyConnected, H = Holddown
Network
10.1.35.0/24
13.1.1.0/24
Displayed Information
Network
Flags
Nexthop Xface
Nexthop Neighbor
Metric
Uptime
Exptime
44.8 Commands for DCSCM
44.8.1 access-list (Multicast Destination Control)
Command:
access-list <6000-7999> {deny|permit} ip {{<source> <source-wildcard>}|{host
<source-host-ip>}|any-source} {{<destination> <destination-wildcard>}|{host-destination
<destination-host-ip>}|any-destination}
no access-list <6000-7999> {deny|permit} ip {{<source> <source-wildcard>}|{host
<source-host-ip>}|any} {{<destination> <destination-wildcard>}|{host-destination
<destination-host-ip>}|any-destination}
Function:
Configure destination control multicast access-list, the "no access-list <6000-7999> {deny|permit}
ip {{<source> <source-wildcard>}|{host <source-host-ip>}|any-source} {{<destination>
Flags Nexthop Nexthop
Xface Neighbor
.D. Vlan2 Directly Connected
.D. Vlan1 Directly Connected
44-84
Metric Uptime
1
1
Explanations
Target net segment or address and mask
Routing state flag
Next hop interface address
Next hop neighbor
Routing metric value
Routing uptime
Routing expire time
Exptime
00:11:16 00:00:00
00:10:22 00:00:00