Planet SGS-6341 Series Command Manual page 360

Valid
Matched
Verifying
InCompleted
Failed
None
Address
Hardware Address
Interface
Port
Flag
19.5.7 show arp traffic
Command:
show arp traffic
Function:
Display the statistic information of ARP messages of the switch. For box switches, this command
will only show statistics of APP messages received and sent from the current boardcard.
Command mode:
Admin and Config Mode
Usage Guide:
Display statistics information of received and sent APP messages.
Example:
Switch#show arp traffic
ARP statistics:
Rcvd: 10 request, 5 response
Sent: 5 request, 10 response
19.6 Commands for Hardware Tunnel Capacity
19.6.1 hardware tunnel-capacity
Command:
ARP entry number matching the filter conditions and
attributing the legality states.
ARP entry number matching the filter conditions.
ARP entry number at verifying again validity for ARP.
ARP entry number have ARP request sent without ARP
reply.
ARP entry number at failed state.
ARP entry number at begin-found state.
IP address of ARP entries.
MAC address of ARP entries.
Layer 3 interface corresponding to the ARP entry.
Physical (Layer2) port corresponding to the ARP entry.
Describes whether ARP entry is dynamic or static.
19-206