Planet SGS-6341 Series Command Manual page 660

Switch(config-router)#neighbor 10.1.1.64 passive
After configured with this attribute and reestablishing the connection , the local side do not attempt
to create connection but stays in ACTIVE state waiting for the TCP connection request from the
partner.
37.62 neighbor peer-group (Creating)
Command:
neighbor < TAG> peer-group
no neighbor < TAG> peer-group
Function:
Create/delete a peer group. The "no neighbor < TAG> peer-group" command deletes a peer
group.
Parameter:
<TAG>: Name of the peer group of which the largest length contains 256 characters.
Default:
No peer group.
Command Mode:
BGP route mode and address-family mode
Usage Guide:
By configuring the peer group, a group of peers with the same attributes will be configured at the
same time so to reduce the configuration staff labor. Assign members to the peer group with
neighbor <ip-address> peer-group <TAG> command.
Example:
Switch(config-router)#neighbor pg peer-group
Switch(config-router)#neighbor 10.1.1.64 peer-group pg
Switch(config-router)#neighbor pg remote-as 100
Related Command:
neighbor peer-group (Configuring group members)
37.63 neighbor peer-group (Configuring group
members)
Command:
neighbor <ip-address> peer-group <TAG>
37-299