port, traffic of VLANs not included are prohibited. The difference between tag and untag mode by
setting allowed vlan: set VLAN to untag mode, the frame sent via hybrid port without VLAN tag; set
VLAN to tag mode, the frame sent via hybrid port with corresponding VLAN tag. The same VLAN
can not be allowed with tag and untag mode by a Hybrid port at the same time. If configure the tag
(or untag) allowed VLAN to untag (or tag) allowed VLAN, the last configuration will cover the before.
Example:
Set hybrid port allowed vlan 1, 3, 5-20 with untag mode and allow vlan 100; 300; 500-2000 with tag
mode.
Switch(config)#interface ethernet 1/0/5
Switch(Config-If-Ethernet1/0/5)#switchport mode hybrid
Switch(Config-If-Ethernet1/0/5)#switchport hybrid allowed vlan 1;3;5-20 untag
Switch(Config-If-Ethernet1/0/5)#switchport hybrid allowed vlan 100; 300; 500-2000 tag
Switch(Config-If-Ethernet1/0/5)#exit
12.1.28 switchport hybrid native vlan
Command:
switchport hybrid native vlan <vlan-id>
no switchport hybrid native vlan
Function:
Set the PVID for Hybrid port; the "no switchport hybrid native vlan" command restores the default
setting.
Parameter:
<vlan-id> is the PVID of Hybrid port.
Command mode:
Port Mode.
Default:
The default PVID of Hybrid port is 1.
Usage Guide:
When an untagged frame enters a Hybrid port, it will be added a tag of the native PVID which is set
by this command, and is forwarded to the native VLAN.
Example:
Set the native vlan to 100 for a Hybrid port.
Switch(config)#interface ethernet 1/0/5
Switch(Config-If-Ethernet1/0/5)#switchport mode hybrid
Switch(Config-If-Ethernet1/0/5)#switchport hybrid native vlan 100
Switch(Config-If-Ethernet1/0/5)#exit
12-65