Planet SGS-6341 Series Command Manual page 720

show bfd neighbor [[<ipv6-address>|<ipv4-address] [details]]
Function:
Show BFD neighbor in switch.
Parameter:
<ipv6-address> specifies the shown neighbor shown of IPv6 addres, <ipv4-address> specifies the
shown neighbor of IPv4 address, IP address refers to remote IP address, details shows the detail
information of neighbor.
Command Mode:
Admin mode and configuration mode
Usage Guide:
Show BFD neighbor in switch.
Example:
Check the relevant information of BFD neighbor.
s5#show bfd neighbor 50.1.1.1 details
OurAddr NeighAddr
50.1.1.5 50.1.1.1
Local Diag: 0, Poll bit: 0
MinTx Int: 400(ms), MinRx Int: 400(ms), Multiplier: 5
Received MinRxInt: 400(ms), Received MinTxInt: 400(ms), Received Multiplier: 5
Local Act Trans Int: 400(ms), Remote Act Trans Int: 400(ms)
Local Act Detec Int: 2000(ms)
Registered protocols: RIP
Echo state: Disable, Echo Detec Int(ms): 2000
Multi Hop: No, Vrf Id: 0
Recv Ctl Pkt Num: 631, Send Ctl Pkt Num: 630
Recv Echo Pkt Num: 0, Send Echo Pkt Num: 0
Last packet: Version: 1 - Diagnostic: 0
Poll bit: 0 - Final bit: 0
Multiplier: 5 - Length: 24
My Discr: 1 - Your Discr: 1
Min tx interval: 400(ms) - Min rx interval: 400(ms)
Min Echo interval: 400(ms)
LD/RD Detec Int(ms)
1/1 2000
41-13
State Interface
Up 3050