Planet SGS-6341 Series Command Manual page 495

Chapter 32 Commands for Static Route
32.1 ip route
Command:
ip route {<ip-prefix> <mask> | <ip-prefix>/<prefix-length>} {<gateway-address> |
<gateway-interface>} [<distance>]
no ip route {<ip-prefix> <mask> | <ip-prefix>/<prefix-length>} [<gateway-address> |
<gateway-interface>] [<distance>]
Function:
Configure the static route. The "no ip route {<ip-prefix> <mask> | <ip-prefix>/<prefix-length>}
[<gateway-address> | <gateway-interface>] [<distance>]" command deletes the static route.
Parameter:
The <ip-prefix> and <mask> are respectively destination IP address and subnet mask, shown in
dotted decimal notation; <ip-prefix> and <prefix-length> are respectively the destination IP
address and the length of prefix; <gateway-address> is the next-hop IP address shown in dotted
decimal notation; <gateway-interface> is the next-hop interface, < distance > is the manage
distance of route management, ranging between 1～255.
Default:
The management distance of static routing is defaulted at 1.
Command Mode:
Global Mode.
Usage Guide:
When configuring the next-hop of static routing, both by specifying the next-hop IP address of the
route data packet and the exit interface are available.
The default distance values of each route type in the layer 3 switch of our company are listed below:
Route Type
Direct Route
Static Route
OSPF
RIP
IBGP
EBGP
The direct route has the highest priority when each route management distance value remain
unchanged and followed by static route, EBGP、OSPF、RIP、IBGP.
Example:
Distance Value
0
1
110
120
200
20
32-134