Planet SGS-6341 Series Command Manual page 715

fsm：Enable the display of state machine for BFD
error: Enable the display of error events for BFD
timer: Enable the display of timeout events for BFD
Command Mode:
Admin mode
Usage Guide:
Enable the relevant debugging of BFD.
Example:
Enable the debugging of BFD.
s5#debug bfd all
41.12 ip ospf bfd enable
Command:
ip ospf bfd enable
no ip ospf bfd enable
Function:
Enable BFD for OSPF protocol on the specific interface, no command disables BFD for OSPF
protocol.
Default:
BFD is not enabled for OSPF protocol.
Command Mode:
Interface configuration mode
Usage Guide:
Configure BFD for OSPF protocol enabled by the specific interface, BFD will inform OSPF after
detect link fault and OSPF will deal with it in best times.
Example:
Enable BFD for OSPF on interface.
s5(config-if-vlan50)#ip ospf bfd enable
41.13 ip route bfd
Command:
ip route {vrf <name> <ipv4-address> | <ipv4-address>} mask <nexthop> bfd
no ip route {vrf <name> <ipv4-address> | <ipv4-address>} mask <nexthop> bfd
41-8