Planet SGS-6341 Series Command Manual page 530

Permit redistributing the network 0:: into RIPng. The "no default-information originate" disables
this function.
Default:
Disabled
Command Mode:
Router mode
Example:
Switch#config terminal
Switch(config)#router ipv6 rip
Switch(config-router)#default-information originate
34.3 default-metric
Command:
default-metric <value>
no default-metric
Function:
Set the default metric route value of the introduced route; the "no default-metric" restores the
default value.
Parameter:
<value> is the route metric value to be set, ranging between 1～16.
Default:
Default route metric value is 1.
Command Mode:
Router mode
Usage Guide:
default-metric command is used for setting the default route metric value of the routes from other
routing protocols when distributed into the RIPng routes. When using the redistribute commands
for introducing routes from other protocols, the default route metric value specified by
default-metric will be adopted if no specific route metric value is set.
Example:
Set the default route metric value of the routes from other routing protocols when distributed into the
RIPng routes as 3.
Switch(config-router)#default-metric 3
Related Command:
redistribute
34-169