Planet SGS-6341 Series Command Manual page 455

added to the NEIGHBOUR list directly. The priority of binding ARP list entries is lower than the static
ARP list entries set by administrator, so can be overwritten by static ARP list entries; but, when
static ARP list entries are deleted, the binding ARP list entries can not be recovered untill the DHCP
SNOOPING recapture the biding inforamtion. Adding binding ARP list entries is used to prevent
these list entried from being attacked by ARP cheating. At the same time, these static list entries
need no reauthenticaiton, which can prenvent the switch from the failing to reauthenticate ARP
when it is being attacked by ARP scanning.
Only after the DHCP SNOOPING binding function is enabled, the binding ARP function can be set.
Example:
Enable the DHCP Snooping binding ARP funciton.
switch(config)#ip dhcp snooping binding arp
Relative Command:
ip dhcp snooping binding enable
30.12 ip dhcp snooping binding dot1x
Command:
ip dhcp snooping binding dot1x
no ip dhcp snooping binding dot1x
Function:
Enable the DHCP Snooping binding DOT1X funciton.
Command Mode:
Port mode
Default Settings:
By default, the binding DOT1X funciton is disabled on all ports.
Usage Guide:
When this function is enabled, DHCP SNOOPING will notify the DOT1X module about the captured
bindng information as a DOT1X controlled user. This command is mutually exclusive to"ip dhcp
snooping binding user-contro"command.
Only after the DHCP SNOOPING binding function is enabled, the binding ARP function can be set.
Example:
Enable the binding DOT1X funciton on port ethernet1/0/1.
switch(config)#interface ethernet 1/0/1
switch(Config-Ethernet 1/0/1)# ip dhcp snooping binding dot1x
Relative Command:
ip dhcp snooping binding enable
30-94