Planet SGS-6341 Series Command Manual page 749

The <ifname> should be valid VLAN interfaces. The multicast data flow will not be forwarded unless
PIM is configured on the egress interface and the interface is UP. If the state of the interface is not
UP, or PIM is not configured, or RPF is not valid, the multicast data flow will not be fordwarded. To
removed the specified multicast routing entry. If all the egress interfaces are specified, or no
interfaces are specified, the specified multicast routing entry will be removed. Otherwise the
multicast routing entry for the specified interface will be removed.
Example:
Switch(config)#ip mroute 10.1.1.1 225.1.1.1 v10 v20 v30
44.3.11 ip multicast unresolved-cache aging-time
Command:
ip multicast unresolved-cache aging-time <value>
no ip multicast unresolved-cache aging-time
Function:
Configure the cache time of the kernel multicast route, the no command restores the default value.
Parameter:
< value> is the configured cache time, ranging between 1 and 20s.
Default:
20s.
Command Mode:
Global Configuration Mode.
Usage Guide:
Configure the cache time of multicast route entry in kernel.
Example:
Switch(config)# ip multicast unresolved-cache aging-time 18
44.3.12 ip pim accept-register
Command:
ip pim accept-register list <list-number>
no ip pim accept-register
Function:
Filter the specified multicast group and multicast address.
Parameter:
<list-number>: <list-number> is the access-list number, it ranges from 100 to 199.
44-25