Planet SGS-6341 Series Command Manual page 605

Specify the retransmit interval of link state announcements between the interface and adjacent layer
3 switches. The "no ipv6 ospf retransmit-interval [instance-id <id>]" command restores the
default value.
Parameter:
<id> is the interface instance ID, ranging between 0~255, defaulted at 0
<time> is the retransmit interveral of link state announcements between the interface and adjacent
layer 3 switches, shown in seconds ang raning between 1～65535
Default:
Default retransmit interval is 5 seconds.
Command Mode:
Interface Configuration Mode.
Usage Guide:
When a layer 3 switch transmits LSA to its neighbor, it will maintain the link state announcements till
confirm from the object side is received. If the confirm packet is not received within the interval, the
LSA will be retransmitted. The retransmit interval must be larger than the time it takes to make a
round between two layer 3 switches. The command can configure on IPv6 tunnel interface, but it is
successful configuration to only configure tunnel carefully.
Example:
Configure the LSA retransmit interval of interface vlan 1 to 10 seconds.
Switch#config terminal
Switch(config)#interface vlan 1
Switch(Config-if-Vlan1)#ipv6 ospf retransmit-interval 10
36.22 ipv6 ospf transmit-delay
Command:
ipv6 ospf transmit-delay <time> [instance-id <id>]
no ipv6 ospf transmit-delay [instance-id <id>]
Function:
Configure the LSA sending delay time on the interface. The "no ipv6 ospf transmit-delay
[instance-id <id>]" command restores to the default.
Parameter:
<id> is the instance ID ranging between 0~255 and defaulted at 0
<time> is the delay time of sending LSA on the interface, which is shown in seconds and ranged
between 1～65535.
Default:
The default delay time of send LSA on the interface is 1 second by default.
36-244